MortiSafe Pro
MortiSafe Pro is the follow on product to MortiSafe. It will be more sophisticated, easier to build but more expensive.
The basic design is a raspberry pi with wifi connection inside the safe with a relay board controlling the safe. There will be a website running inside the safe which subs will be able to interact with for self-locking, and that site will regularly check in with an internet website which controllers (nominated by the sub) will be able to use to specify lockups for the sub.
However, the public website will not be required for the operation of the system - if it goes down or a user's system becomes unable to connect to the internet, time control and password-based unlocking will still work the same.
Initial functionality
What follows is a minimal set of functionality which the system could be release with, but with an intention to advance it to the full functionality over time.
Once the system is installed, the sub will be able to connect to a website (run from inside the safe) which
Potential problems
- System will rely on the pi's wifi chip being able to talk to the user's home wifi router - being inside a steel box may cause a problem
- The installation process will have to include the user configuring their home wifi router's password. I've yet to see what the software is like for that, but I imagine it will require plugging an HDMI monitor into the pi just to be able to configure the networking - after that, everything can be done by website from the user's PC.
