View source for Putting together MortiRemoteSafe from purchased assembled components

If you've bought a MortiSafe from me, 

==Parts I supply==
You should now have from me:

# A MortiThingy - two small circuit boards with buttons, an aerial and a USB socket
# A MortiReceiver board - a circuit board with four blue blocks, lots of screw terminals and an aerial
# Connected to the MortiReceiver board, a Safe Cable, which is a cable with screw terminals on the end
# Connected to the MortiReceiver board, a buzzer and a battery clip
# A PP3 battery
# A washer

==Parts you supply==
And you should also have:

# A digital safe
# A power adaptor, 9v to 12v

==Stuff you should download==

Download this zip file to your PC. Create a folder on your PC and copy the files from the zip into the folder.

These files will include:
# MortiSafe.inf - a file used to tell your PC how to talk to the USB device
# MortiSafe_Test.exe - a program used to test the MortiSafe
# MortiSafe_Dom.exe - a program used by dominants to generate key codes
# MortiSafe_Sub.exe - a program used by submissives who have been given key codes from their dominant
# MortiSafe_Self.exe - a program used by anyone using the safe for self-bondage

==How to build, quick summary==

There may look like a lot of steps to building the MortiSafe but that's only because it's in a lot of detail. The basic steps to it are:

# Cut the cable of your power adaptor and connect it to the MortiRemote
# Cut a wire in your digital safe and connect it to the MortiRemote
# Plug the MortiThingy into your PC
# Download some software
# Use it

==Checking the MortiReceiver wiring==


==Powering the MortiThingy==

# Download some files to your PC
# Plug the MortiThingy into a USB port on your PC
# When it asks for a driver file, point it at one of the files you downloaded

==Powering and testing the MortiReceiver==

# Take your power adaptor
# Cut off the end with the socket which usually plugs into the appliance, so you have most of the cable still attached to the plug you put into the wall
# Clean 1/2 in 

==Wiring the safe==

# Take the back off the door of the safe (usually 4 screws)
# You'll find 2 wires coming from the battery compartment to the control board
# Cut one of them (whichever's longest)
# Clean some insulation off both ends of the wire
# Put each end of the wire
# Push those wires into the ends of the Safe Cable and tighten screws to hold them in

==Using the safe==

# You can then run programs to lock and unlock the safe, lock it for a specified duration, etc

==Uninstalling the MortiSafe==

If you should want to, you can very easily turn the MortiSafe back into a normal digital safe just by unscrewing some wires.